Beam Shout ts Guía de usuario descargar pdf (Pagina 19)

SHOUT ts User’s Manual Version 1.0.1

until user decides to either resend (enqueue) or delete. The Outbox stores the

oldest message on top of the list.

For each message queued in the Outbox waiting to be sent, the ts attempts up to

three times to transmit. After three failures, the message will be dequeued to

avoid draining the battery. User has to manually requeue a message. If the ts is

at a location not suited for transmission (under heavy foliage), user has to

monitor the Outbox and repeatedly requeue until the message is successfully

transmitted. The symbol appears on top of the screen when there is a

queued or dequeued message(s) in the Outbox.

NOTE: The SHOUT ts will NOT resend “failed messages” even after the Iridium

signal becomes available. User has to manually requeue failed messages in order

to resend. This is to prevent unintentional depletion of battery power in case there

is large number of failed messages in the Outbox. Failed Cancel 911 message also

needs to be requeued.

Sent folder contains messages successfully sent to a NOC server. A message can

be resent, forwarded or deleted. Resend puts a message back to the bottom of

the Outbox folder’s sending queue. Forward takes user back to the Compose

menu for additional information to be entered. User can then resend the message

after modifying it or cancel the process. Delete permanently removes the

message from the Sent folder. The ts stores messages in the Sent folder with the

newest message displayed on top of the list.

Compose menu allows user to enter, edit and send canned messages, free-text

messages or a combination of canned and free-text messages to: (1) a NOC

server, (2) to a pre-defined list of email addresses or/and (3) to any email

addresses entered via the keyboards.

The SHOUT ts can be assigned to “point” to a specific NOC server (either NAL

Research’s mapping server or application developer’s server) by an Iridium

airtime reseller when services are purchased. SatTerm software is used to create

and save predefined email addresses onto the ts’ contact list. During setup

SatTerm requires connectivity between the ts and a NOC server to synchronize

the lookup table of short codes. As with canned messages, short codes are used

to map the actual email addresses to a lookup table located at a NOC.

When Compose is selected, a screen will appear with two distinct regions—“To:

Sent

Compose

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 41 42

Sin comentarios

Beam Shout ts Guía de usuario Pagina 19